VPN configuration
Start
Visit the settings page
Open the browser, enter the IP address of the box, click to enter the Settings-Proxy Settings page, click the VPN configuration button, and enter the configuration page.
Log in
Enter default account password
Username: adminPassword: 123456
Import node
Click the Import button on the page
In the dialog box that pops up, enter the URL of the V2Ray you purchased, then click OK and wait.
If successful, the page will automatically redirect. If unsuccessful, please check if the URL is entered correctly and make sure to purchase a V2Ray node.Right-click on the option to the right of "SERVER" to display the node list.
Test delay
There is a small box on the leftmost side of the node. After checking it, PING and HTTP selections will appear above it to test whether the node is available and has latency. Try to choose a node with lower latency.(Some nodes seem to have normal latency, but they cannot access the network when connected. If you encounter an inaccessible situation, please try several nodes.)
Enable VPN
Select a node: After testing the latency, find the appropriate node and right-click to select.
Start VPN: Click the "Ready" button in the upper left corner, right-click and select to start VPN.
After successful startup, "Running" will be displayed in the upper right corner, indicating that the VPN has been turned on normally.
Multiple nodes can be selected. After selecting multiple nodes, the system will automatically load balance, and the node with lower latency will be used first
Turn off VPN
To turn off the VPN, find "Running" in the upper right corner and click to turn off the VPN.
Replace node
Find the node in use and click Cancel, then re-select the desired node. Click "Ready" in the upper right corner again.
Advanced settings
(Only use when network shunting needs to be set, do not change any default configuration if you have no foundation)Click Settings in the upper right corner
The default configuration usually does not need to be changed.
Transparent proxy/system proxy, settings
Close: All websites do not use proxies by default.Enable no diversion: All website traffic goes through VPN.Enable mainland allowlist mode: When accessing web pages on allowlist, use the local network; for web pages not on allowlist, access through VPN.Enable GFWList mode: Websites blocked by the firewall are automatically accessed through VPN, while unblocked websites are accessed through the local network. (When using GFWList mode, the GFWList table needs to be updated. Please select the proxy to start in the diversion mode first, and then update again, otherwise the update may fail.)Select the desired mode and click "Save App". Please leave other configurations as default.
Last updated
